What are the maintenance procedures for Automatic Flute Laminator?

Maintenance of Automatic Flute Laminator:

1. The staff responsible for maintenance should inject an appropriate amount of gear oil into the Automatic Flute Laminator every month, and change the oil every six months.

2. Open the limelight cover every six months, and refuel the two holes once. The linear guide bearing above the suction nozzle should be lubricated once a week.

3. Keep the suction nozzle moving up and down freely, and at the same time, pay attention to the cleaning of the inside of the suction nozzle.

4. The staff should always check the tightness and wear of the Automatic Flute Laminator belt.

5. Inject an appropriate amount of grease into the bearing of the Automatic Flute Laminator every week, and inject an appropriate amount of mechanical oil into the machine every week.

6. Pay attention to remove the foreign matter in the air duct of the suction nozzle, and clean up all the limelight.

7. The filter of the vacuum pump of the machine should be cleaned once a month.

8. Keep the surface of all rollers clean at all times during work to avoid solid objects attached to them, and pay attention to the sudden expansion of colloidal silver due to chemical solvents during operation, and be careful to prevent the rubber rollers from being extruded due to excessive extrusion. After the work is finished, the coating and the rubber roller must be back pressed together before leaving get off work to prevent the rubber roller from being elastically fatigued by long-term extrusion and affecting its life.

9. The motors in the pressing and feeding parts of the Automatic Flute Laminator should be replaced with high-speed grease every six months

Here is a brief introduction to the maintenance and maintenance of Automatic Flute Laminator, you can refer to it