Fully Automatic Die Cutting Machine?

2023-11-28 17:30:09

First, the operator should pay attention to dust and clean. In actual production, a large amount of waste paper and paper hair will be generated when cutting the carton. If you don't pay attention to it, you will enter the chain transmission site, the mold cutting platform and some rotation movements, and may block the photoelectric detection header and so on. Cause failure. Therefore, be sure to put Fully Automatic Die Cutting Machine's body cleaning work first, and then it can ensure that the machine runs without failure.

Fully Automatic Die Cutting Machine

Secondly, Fully Automatic Die Cutting Machine. Fully Automatic Die Cutting Machine active is the main motor driving the slider and pulley, and then driving the four -pair of elbow poles to exercise. It reaches 6,000 / hour in high -speed work. It is troublesome to have no good lubrication and cooling. Lubricating maintenance is divided into daily guarantee, Zhoubao and Yuebao, etc., as follows:

The maintenance machine must be done by each operator. Because the machine is not well maintained, it increases maintenance costs and corporate expenses. Second, it has a lot of damage to the machine to shorten the service life of the machine; the three affect the operation and delay production. The machine failure will definitely affect the emotions and delivery period of the operator.

Finally, the common failure of Fully Automatic Die Cutting Machine should be eliminated in time. In terms of mechanical, Fully Automatic Die Cutting Machine common faults are phenomenon of platform pressure on the platform. This situation is mostly a foreign body falling into the mold cutting. Generally, the two wedge -shaped positions under the dragging shaft should be adopted. At the same time, the platform should be turned to the upper limit point. At this time, the relative position of it is to the upper platform to ensure the distance between the four corners of the mobile platform and the net platform (place where the template is cut), so that the problem can be solved.Electrical failures are: Fully Automatic