Fully Automatic Folder Gluer's operation steps:

Fully Automatic Folder Gluer's operation steps:

1. Carefully check the work order and sample to determine the use of the paste glue used and prepare it.

2. Adjust the slope and height of the bracket of the benchmark area to enable the products to be used to move forward smoothly without the occurrence of bondage. Make it suitable for the specifications of the color box.

3. Adjust the width of the box baffle, should be parallel on both sides, and just put down the semi -finished color box to be produced. The two -sided baffle is less than 1mm from the color box, and then adjusts the limited bolt There is no bond.

4. Adjust the glue cylinder, check whether the glue of the glue cylinder is sufficient, the amount of glue should be immersed in 80 % of the rubber wheel, and then the plastic cylinder and upper glue position should be adjusted.

5. Adjust the belt belt and paste box guide rail, and then adjust the configuration box host and the rotation pressure, and the cross coordination with the belt.

6. Open the power switch, the main motor switch and the vibration switch are the key. After the machine adjustment, press the "operation" or "inch motion" key, press the "paper" key to debug the machine, and check whether the performance of the machine is abnormal. The phenomenon of skewing should be corrected immediately.

7. After the debugging OK, the first test machine is performed 5-10 to confirm the speed of the position and forming specifications.

8. When the box is paste, pay attention to the paste of the paper, not over -line, offline or misplaced, so as not to affect the appearance and molding effect of the color box.

9. The first confirmation: Strictly follow the signed sample method.

10. After the production is completed, clean up the hygiene of the machine and keep it clean.

The above is all the boot steps of Fully Automatic Folder Gluer. You can refer to it