Installation considerations for Automatic edge sealing and shrinking packaging machine

Installation considerations for Automatic edge sealing and shrinking packaging machine

With the improvement of quality of life, people's requirements for product packaging have increased. Nowadays, the sales of most products are closely related to whether the packaging is good or bad. Therefore, a lot of effort has been put into product packaging to improve sales. It shows the appearance of the product, and shrinking machines have become an important part of enterprise packaging machinery. Special attention should be paid to the following points when installing Automatic edge sealing and shrinking packaging machines:

1. Automatic edge sealing and shrinking packaging machine: The winding machine consumes a lot of power, so the input power supply must have a larger power supply than the nominal nameplate shrinking machine, otherwise it is easy to burn the circuit or electrical components.

2. Automatic edge sealing and shrinking packaging machines must be grounded to protect personal safety.

3. Automatic edge sealing and shrinking packaging machine. Each machine must be connected correctly to the power cable for power supply. Violating regulations may cause electric shock.

4. When the automatic edge sealing and shrinking packaging machine provides a three-phase 380V power supply, you must also input a zero line, which is a standard three-phase four wire, such as vacuum packaging machines and other packaging equipment.

Otherwise, the machine will not work and can easily burn out internal electrical components.

5. Automatic edge sealing and shrinking packaging machine must be installed horizontally, otherwise it will shorten the service life of the heating tube.

6. The automatic edge sealing and shrinking packaging machine will continue to be used for more than 3 months. The shrinkage reaction at room temperature will be checked, and the line will be replaced appropriately according to their aging level.

7. Automatic edge sealing and shrinking packaging machine: The operation of mechanical components that operators are not allowed to touch, especially during contraction in high-temperature rooms, can easily cause burns.

8. After packaging the Automatic edge sealing and shrinking packaging machine, the heating switch should be turned off to allow the transport motor and fan motor to continue running for about 10 minutes, and then cut off