Fully Automatic Flat Die Cutting and Creasing Machine's maintenance is as follows:

Fully Automatic Flat Die Cutting and Creasing Machine's maintenance is as follows:

With the advancement of paper quality, Fully Automatic Flat Die Cutting and Creasing Machine has been widely used in the paper packaging and printing industry. However, due to the lack of knowledge of maintenance of adaptation, the problem of rigidity caused more problems, which directly affects the normal operation of consumption, which has caused the advancement of consumption capital, which not only disrupted the consumption setting plan, and has a great impact on the delivery period and has a great impact on the delivery period. Essence In order to further improve the operation process of Fully Automatic Flat Die Cutting and Creasing Machine, carry forward the new techniques of mold cutting machines, and improve the level of contemporary operation. Based on the experience of this year, the author summarizes Fully Automatic Flat Die Cutting and Creasing M. achine Some maintenance points and academic knowledge, exchange and share with their colleagues. First of all, the operator must prevent dust and cleanliness. In practical consumption, when the mold cutting box will produce a large amount of waste paper and paper hair, it will enter the chain transmission part, the mold cutting platform and some rotating activity parts without stability, and may block the optoelectronics. Detect the number to form a problem. Therefore, it is definitely necessary to put the cleaner of the mold cutting machine first, and then it can ensure that it is rigid and wrong. Secondly, Fully Automatic Flat Die Cutting and Creasing Machine. The main measure of the mold cutting machine is that the main motor launchs the slider and the pulley, and then the four -pair of elbow rods are launched to move. It reaches 6,000 / hour in high -speed events. It is very troublesome to have no good smoothness and cooling. Smooth recipes are divided into daily guarantee, Zhou Bao and Yuebao, etc., meticulous in the following table: It is necessary to do it by every operator. Due to the poor raising well, the cost of maintaining maintenance and corporate expenditure are increased; second, it has great harm to the dullness, causing the dull service life to shrink; the three affect the operation and delay the consumption. Polying problems will definitely affect the operator's mood and delivery period. At the end, the common problems of the mold cutting machine should be cleaned in time. In terms of rigidity, Fully Automatic Flat Die Cutting and Creasing Machine common problems have platform pressure signs. This state is mostly a foreign body falling into the mold cutting point. Ordinary should take the two wedge -shaped positions under the shaft rod. At the same time, the platform should be turned to the upper limit point. At this time, the relative position of it is from the upper platform, and the four corners of the mobile platform and the isolated three corners of the mobile platform (the middle of the module cutting plate) (the middle of the template plate) can be isolated, so that the punishment problem can be dealt with. Electrical problems include: Fully Automatic Flat Die Cutting and Creasing Machine intermediate control system accepts the programmable logic controller (PLC). Logic diagram. Therefore, when there is a problem in electrical, the maintenance personnel are nervous to understand their trapezoidal logic diagrams, so as to identify and find the cause of problems, so that the problem will be dealt with quickly. Regardless of whether it is fully automatic or semi -automatic flat -pressure flat mold cutting machine, professionals need to stop refueling and support. It is necessary to understand the rigid layout and performance, so that it is rigid.