Automatic Flute Laminator why suddenly stop during work

Automatic Flute Laminator why suddenly stop during work

Automatic Flute Laminator sometimes occasionally happens during the work. What is the situation? It was because I did not know why during the work of work suddenly stopped and stopped working. There is a certain order of investigation. Each machine has a code. You need to take a closer look or pay attention to the time. Let's tell you the common one. The eye can be seen that the water level does not reach the prescribed water level display E4 during the eight minutes; , Different clothing, repeatedly correct the number of corrections exceeding the regulations, display E3;

Automatic Flute Laminator sometimes occasionally happens during the work. What is the situation? It was because I did not know why during the work of work suddenly stopped and stopped working. There is a certain order of investigation. Each machine has a code. You need to take a closer look or pay attention to the time. Let ’s tell you the common one below. Remember to try it:

First, the water pressure or the water inlet filter is blocked, which is very slow in water. The eyes can be seen. It has not reached the prescribed water level to display E4 during the eight minutes;

Second, the drainage is blocked. You can see the drain pipe out.

Third, the upper cover switch is poorly exposed to display E2;

Fourth, the clothing is partial, the repeated number of corrections exceeds the requirements display E3;

Fifth, the water level sensor is moisture, and the severe moisture shows E6. The mild moisture is displayed as a state of water -free or commonly used. The procedure time does not display two horizontal lines directly to display the time. After the discharge, it is thought that it will continue to drain and do not start dehydration. This machine's failure is very high. You need to carry it out of the sun in a day of sunlight. The problem will basically solve the problem.

If the above situation is not, it is a pity to tell you that the motherboard of this machine is basically unavailable, and replace a new motherboard in time.

  Hengyun Machinery Technology (Dongguan) Co., Ltd. is an enterprise developing and selling post -printed equipment. The products include smart high -speed Automatic Flute Laminator, smart high -speed turning machine, paper stacking machine, corrugated paper machine, and whole set of mounting paper connection connection. Equipment, etc., can be designed to produce supporting and customized products according to the special requirements of the customer.