General Fully Automatic Uv Varnishing Machine should pay attention to

General Fully Automatic Uv Varnishing Machine should pay attention to

Pay attention to the following points when using the UV light machine:

1) Fully Automatic UV Varnishing Machineuv's normal use temperature is 50-55 ° C. When use in low temperature in winter, it needs to be heated by reincarnation of UV optical oil in a constant temperature water area to achieve the viscosity of the design and use, which is conducive to UV optical oil. Linking and rapid solidification.

2) Fully Automatic Uv Varnishing Machineuv Optor oil should be 50-60 ° C. When the UV light is sprained by the UV light, it should be 50-60 ° C. Due to the rapid solidification of UV optical oil at this temperature, it has strong adhesion after curing. In other words, the lower the temperature is not the better under the UV light. Especially in the winter low -temperature plant light, the adhesion is not good and the flowing level is not good. The main reason is that the solid effect is poor to the bottom of the bottom.

3) Fully Automatic UV Varnishing Machineuv on the light machine should be placed in a position that the sun cannot directly illuminated, otherwise UV optical oil will be solidified on the coating roller under ultraviolet light in the sun. If you can't avoid direct sunlight, you should also block the sunlight with red and black curtains.

4) Fully Automatic UV Varnishing Machine on the light that the UV optical oil that was scraped when light on the light will be printed on the ink that has been printed on the printed material to the UV optical oil on the light machine to make the light oil on the color. After precipitation, these optical oils can also be inherited.

5) Fully Automatic Uv Varnishing Machineuv's photoretically caused by photoresters in optical oil and diluents have a certain stimulating effect on human skin. Therefore, in the upper light manipulation, if the skin encounters UV light oil, it should be washed off immediately with soapy water, otherwise the skin may be red and swollen and foam.

6) Fully Automatic UV Varnishing Machineuv Optical Oil use viscosity varies from the type of UV light machine. The dedicated optical oil should be selected according to the model of the optical machine. If the UV photoresmal viscosity does not meet the viscosity required by the optical machine, it can be removed with diluted agent or adhesive with thickening agent. However, adjusting this will lose the curing speed, brightness, and adhesion of UV optical oil. It is not recommended to change the appropriate dedicated optical oil as much as possible.

7) Fully Automatic Uv Varnishing Machine should pay attention to cleaning the axis. Because UV light oil flows to the rolling department of the transmission shaft of the UV, it will stick to the transmission shaft at high temperature to affect the transmission.

8) Fully Automatic UV Varnishing Machine Machine gold card paper, PFT and other special printed materials should use special UV light oil according to their respective surface properties. Refer to Article 6.

UV optical oil is a non -conjunctival material in the accurate storage environment. It will be solidified immediately after the ultraviolet light, such as sunlight, welding arc light, and UV lights. Lighting sources such as solar lights and incandescent lamps used in the manipulation room will not cause UV optical oil to be solidified.