The basic principles of Automatic Folder Gluer

The basic principles of Automatic Folder Gluer

The basic principle of Fully Automatic Folder Gluer: Fully Automatic Folder Gluer's working principle is that after starting the power supply, the entire teleportation began to move. Place the molded semi -finished carton in Fully Automatic Folder Gluer into the paper. The box is sent to the middle of the belt according to the set paper reported by the paper block (if the semi -finished carton passes through the surface of the membrane or light, and after entering the middle section, the cope with the adhesive gun can be used on the inner edge.) The conveyor belt sends the carton to the part of the larvae to press it.

Fully Automatic Folder Gluer Machine Time: 1, Fully Automatic Folder Gluer When oblique during sticking, o gloss is not firm: you can check-the amount of glue can be applied. If the amount of glue is too small, it will cause the adhesive to not be firm, so one-must have experience to grasp the amount. 2 Scratches on the surface of the rubber box: Especially small boxes are often difficult to use belt creases. You can first cover a layer of film, but the adhesive position cannot be covered, otherwise it is not easy to play. 3 The direction of the rubber box is incorrect: This requires the position of the plastic box and the pressure of the pressure of each ministry. 2. Hook Box Box Machine Box Hokusca, dislocation, and poor molding, which has a lot to do with the quality of the paste box machine. It is recommended not to be too fast, the slower effect will be better. Consultation hotline: +86 13570431518