Analyze the security operating procedures of Fully Automatic Uv Varnishing Machine, a total of 14 points, as follows:

Analysis of 14 major security operating procedures for Fully Automatic UV Varnishing Machine Analyze the security operating procedures of Fully Automatic Uv Varnishing Machine, a total of 14 points, as follows: 1. Fully Automatic UV Varnishing Machine should be operated by a special person according to the "Operation Manual". 2. Staff must wear qualified labor insurance supplies in accordance with relevant regulations. They should wear tight work clothes and work caps to avoid hair or clothes from being involved in the machine, causing physical danger; 3. Check the ventilation situation before booting. 4. Check the foreign objects of the machine, check the safety device, oil window oil level, clean up the photoelectric detection device, and regularly add the specified models of lubricating oil to clean the filter; 5. Before turning on, confirm that no one is inside the machine; 6. When any maintenance, maintenance, and cleaning of the machine, the machine must be stopped and the total power supply is disconnected; 7. Regularly check whether each safety cover and safety device are valid, do not use it when the machine is operating normally; 8. The use of bright fires in the workshop. The light material and alcohol should be used. After use, it should be handed over to the pilot to keep it properly after use. 9. When Fully Automatic Uv Varnishing Machine is running, do not put any part of the body in the machine or close to the motion component, do not climb to the machine. Then officially start work 10. During the running process of the UV light machine Fully Automatic UV Varnishing Machine, pay attention to observing whether there are abnormal conditions in the machine everywhere, and checking the products at any time. 11. Keep Fully Automatic UV Varnishing Machine's working environment and clean and cleaning of the machine itself. Smooth such as oil and oil pollution on the floor and pedal on the floor must be removed immediately. The machine causes damage; 12. The operator should use the pump to run at least twenty minutes before stopping the work. After confirming the safety 13. The machinery failure occurs, and the mechanical and electrical professionals should be excluded. Equipment accidents should be protected. The staff of the machine should protect the scene and report to the workshop and equipment department in a timely manner; 14. Regularly maintain and lubricate the Fully Automatic UV Varnishing Machine. When the machine is not used for a long time, the machine should be cleaned and maintained and the dustproof treatment should be done.